Zimmer Biomet Zfx EvolutionNEXT, Руководство пользователя

Страница: 41 / 66

41
4.7.2.3 Parameters
“Parameters”: The way in which a hole is to be filled can be set here.
1 –
3
Sliders, each with 5 steps for setting the filling mode
1 Keep borders
Step Description
No The Assistant automatically cleans the hole borders in order to achieve better filling.
Fewer
The border retention is progressively weighted.
Standard
More
Exact
The border of the hole is not changed. This can lead to a hole not being filled as, without filling,
its border geometry is too complex.
2 Reliability
Step Description
Lowest
With the lowest reliability, the Assistant takes virtually no account of the shape of the fill. Filling the holes takes priority.
Depending on the border geometry, this can sometimes result in larger artefacts or holes being only partially filled.
Low
The Assistant pays increasing attention to homogenous transitions at the borders of the hole. Partially filled holes are
not allowed, which means that a hole may possibly not be filled if the hole geometry is too complex.
Standard
High
Highest Additional calculation effort is invested in order to achieve the most homogenous filling possible.
3 Resolution
Step Description
Lowest Reduces the resolution relative to the “Standard” step by approx. ¹⁄₃
Low Reduces the resolution relative to the “Standard” step by approx. 1⁄₆
Standard The Standard fill resolution is oriented towards the average resolution of the hole border
High Increases the resolution relative to the “Standard” step by approx. 1.5 times.
Highest Increases the resolution relative to the “Standard” step by 3 times.
4.7.2.4 Selection
The selection of triangles can be defined here. These are deleted in the next step, thereby removing
troublesome structures.
1 Selection of contiguous surface elements having no more than
the number of triangles specified in the box on the right
2 Maximum number of triangles for the selection of contiguous
surface sections
3
Selection of triangles which are not correctly bonded to the surfaces
4
Selection of all border triangles
If the limit is active on selected areas, then all actions under “Selection” are only carried out on the marked area.
1
2
3
1
2
3 4