Zimmer Biomet Zfx EvolutionNEXT, Руководство пользователя

Страница: 48 / 66

Zfx™ Evolution NEXT
48
6.1 Overview of possible scanning processes
×
Standard plaster models
×
Fully anatomical crowns/bridges
×
Single veneered copings/wax-ups
×
Anatomically reduced veneered copings and frameworks
×
Bridge frameworks / wax-ups
×
Inlays / Onlays / Inlay bridges
×
Gum models
×
Situation scanning
×
Implant / scan body (where available in Zfx Manager 2.0)
×
Squash bite or aligned jaw model
×
Marker setting
NOTE
The scan order is defined in Zfx Manager 2.0 or in the configurator.
From this, the scanning software determines the different scanning steps.
NOTE
The use of Zfx Arti-Synchronizer for Zfx Evolution is recommended as this has been designed for the system.
(
→ Chapter 1.6.2)
6.2 Scanning procedure
Step Description → see Chapter
1 Open the scan order
Enter the order in Zfx Manager 2.0 specifying the required
restorations, patient data, material information etc.
4.4 Operating mode – Configuration
2
Start the scan order
Start the scan order via Zfx Manager 2.0 or directly from
the scanning program
4.5 Starting the scan
3 Scan object Place the object to be scanned in the scanner 5 Placing the object to be scanned in the scanner
4 Adjust the brightness Determine the optimal illumination for the scanning area 4.5.5 ”Brightness setting”
5
Define the
scanning area
Select the scanning area by adjusting the frame 4.5.3 “Defining the scan area”
6 Tooth selection Select the scanning area with the position circle 4.5.4 ”Tooth selection”2]
7 Start the scan
Start the scanning process by clicking the
right arrow button
4.5.2 ”Scan Assistant/Help”
The scanner scans the object and gathers the data (this process can take a few minutes).
8
Additional scan
The user has the option of adding further scans to the
data set
4.5.6 ”Additional scan in scan step”
9
Select the data set Delete superfluous data 4.5.8 ”Selecting and deleting a data set”
10 Complete scan*
*or repeat the whole scan step → go back to Point 4.
Depending on the number of process steps displayed in the Scan Assistant, the scan procedure will be repeated with the points 1 to 10 for process step two
and for all following process steps of a scan order. It can only be extended by means of the “Alignment of data sets” function (
→ Chapter 4.5.9).
6 Scanning process