ZIEHL-ABEGG FXDM25, Руководство по эксплуатации

Страница: 55 / 123

Info Current actual value measured at sensor 1 (unit depending on programming).
0 ° C
E1 Actual
Info Display for
“
actual value 2
”
for operation with two sensors.
Display if function not active:
|
- - - - -
|
0 ° C
E2 Actual
Info Display of the active target value at which the device operates.
“
Setpoint1
”
Menu
“
Setting
”
“
Setpoint2
”
Menu
“
Setting
”
“
Ext. Setpoint
”
= setting by external signal 0-10 V. With activated manual mode the
display constantly changes between actual value and value for manual mode.
Display for operation with two control circuits:
“
1.Setpoint 1
”
or
“
1.Setpoint 2
”
for control circuit 1
“
2.Setpoint 1
”
or
“
2.Setpoint 2
”
for control circuit 2
0 ° C
Setpoint1
Info Only for mode 4.02 , 4.03 , 5.02 with setpoint depending on outdoor temperature (E2
function =
|
6E
|
).
100.0 Pa
Setpoint control
Info Inverter output frequency.
0.0 Hz
Frequency
Info
“
2. Modulation
”
for control circuit 2
(Only active in operation with a second control circuit)
0 %
1. Control
Info Display of motor current (Metering precision approx. +/-10%)
0.0 A
Motor current
Info Momentarily status for minimum speed cut off
“
ON
”
= switch off, if Setpoint (+/-
“
Min. speed cut off
”
) is reached.
“
OFF
”
= no switch off that means operation with minimum rate of air.
Display for operation with two control circuits:
“
1. Min. speed cut off
”
for control circuit 1
“
2. Min. speed cut off
”
for control circuit 2
OFF
Min. speed cut off
Operating Instructions Fcontrol
–
model series FXDM25/32AM Programming
L-BAL-E212-GB 1451 Index 003 Part.-No.
55/123