Setup Mode
JesterML Operating Manual
73-406-00 Issue 2.0
43 of 73
be cleared, and a new patch automatically created. The preset channels will be
patched as shown in the default patch table above, and the fixtures will be begin at
the next available DMX address.
Previewing the patch
While in DMX Patch Mode, the brightness of the selected fixture is set to 100%, so
that the fixture can be identified in the rig and the patch visually confirmed. Other
fixtures are set to 0%. To make it easier to identify fixtures in DMX Patch, you may
wish to first Home all of the fixtures in a normal operating mode before entering
Setup. This will ensure all LTP channels are set to default values.
All of the preset faders are active in DMX patch mode, so that they can be faded up
and down to test the patch easily. If a wing is in use, faders on the wing can be
used.
For the outputs to be seen, the Grand Master must be raised, and the desk must not
have Blackout active.
Leaving DMX Patch Mode
To leave DMX Patch Mode, use the cursor buttons to move to select <OK> then
press ENTER. You will be returned to the Setup menu. If you wish to discard any
changes that you have made to the DMX Patch and restore the previous patch, then
use the cursor buttons to move to select <OK>, and while holding down SHIFT, then
press ENTER.
Assigning Fixtures
The JesterML has a comprehensive built-in library of over 1700 different fixture types
from 125 manufacturers. This library is regularly added to and updates are available
from the Zero 88 website. If the fixture you want to use cannot be found on the desk,
you can create the personality information for it using the Fixture Type Editor utility
supplied on the CD with the desk (a Windows® PC and a USB Memory Stick are
required). This is also available from the Zero 88 website, together with a support
forum where you may find another user has already created the fixture personality
information you need and uploaded it.
1.
To assign your fixtures, you must first enter Setup. To do this, hold down SHIFT
and press the MODE button for 1 second. Once in Setup, use the cursor
buttons to navigate to <Assign Fixtures> and press ENTER
2.
Now press the Multi-Function-Key of the fixture you wish to assign.
3.
Press the down cursor button to move to the next line on the LCD, and then use
the left & right cursor buttons to select the manufacturer of the fixture.
4.
If instead of using fixture personalities from the main library, you wish to load
personalities from a file you have created with the Fixture Type editor, select
Load From USB
at this point, and select the filename using the left & right
cursor buttons. The desk will take an internal copy of the file so that it can be
used again in future without the need to reload it again from memory stick.
5.
If instead of using fixture personalities from the main library, you wish to load
personalities from a file you have previously assigned fixtures from on the desk,
select
Load User File
at this point, and select the filename using the left & right
Содержание jester 24
Страница 1: ...OPERATING MANUAL including ...
