Zenith Z-100 Series, Руководство пользователя

Страница: 28 / 150

page 27
WINCHESTER SUPPLEMENT
The PART Utility
The display illustrated in Figure 5 shows the partition name,
operating system name, percentage of disk space, and size
in kilobytes for each partition. The total percentage, and the
number of kilobytes currently allocated and not allocated on
the disk, are shown at the bottom of the table.
You will also see the number of the partition that is assigned
to be the default boot partition (if one is assigned), its name
and operating system. Below that there is a short "menu" that
will allow you to select a different default boot partition, change
the arrangement of your Winchester disk partitions, or exit
from the PART utility. Your choice is entered by pressing the
g g, or[(key.
The display is similar to the one that will appear the first time
you run PART on a new Heath/Zenith Data Systems Z-217
Winchester disk, or immediately after you have run the PREP
utility. If you have already used PART, then portions of your
display may vary from the one illustrated in Figure 5.
Modifying the Default Boot Partition
The "default boot partition" is the one that will be selected
when you boot your system without specifying a partition
name (as with an auto boot operation). (In order to select
any other partition during the boot process, you must specify
the partition name, and sometimes the system name, in the
boot command.)
Press the
Q key to modify the default boot partition. The
menu that was displayed at the bottom of the screen as
shown in Figure 5 will disappear. The cursor will move
to the current default boot partition number as shown in
Figure 6.