page 41
WINCHESTER SUPPLEMENT
installing Operatirmg Systems
Z-DOS
NOTE: Unless you have previously duplicated your Z-DOS
Distribution Disks with the MAKE utility, your Desktop Com-
puter will start a duplication process when you boot from your
Z-DOS Distribution Disk I. Use the following instructions to
install Z-DOS on your Winchester system.
Turn on your Computer (if it is not already on), place
your Z-DOS Distribution Disk I (you must have Z-DOS
BIOS version 1.10 or later) in the floppy disk drive, and
close the door.
If your Computer is not set up to boot from the floppy
disk, press the
Q>g~
key t o stop any auto boot pro-
cess. Then press the [g key and then the [g key, followed
by the ~ g g ] key.
In a moment, the Z-DOS initial messages will appear and
you will be asked to enter the date. If your disks have not
been previously duplicated using the automatic MAKE utility
installed on your distribution disks, you must press the
(ggg
and g key simultaneously. You will be asked if you want to
discontinue the batch process. Press the g key and then the
g~ g
g k e y. The Z-DOS prompt will appear.
Type
FORMAT E: /S/V
and press the ggg
+g
key. The E represents the first
Z-DOS Winchester partition (under Z-DOS, drives A and
B are assigned to the built-in floppy disk, drives C and
D are assigned to the external 8" drives if present, and
drives E and F are assigned to the two Winchester parti-
tions). The N switch will locate any bad sectors and lock
them out of the system. The /S switch will establish the
operating system on the disk. You will see:
Содержание Z-100 Series
