Zenith Z-100 Series, Руководство пользователя

Страница: 111 / 150

Page 4-19
• Sim i l ar l y , u se two ¹6 x si s " self-tapping screws
t o secure a s l i d e r a i l t o t h e r i g h t s i d e o f t h e
center base as shown in Part B.
Refer to Pictorial 4-24 for the foll o w i n g steps.
• P osi ti o n o n e of t he s li de rails near the left side
o f the c e n ter b ase as sh ow n i n P a r t A . T h e n
hook the free end of the spring into the indi-
cated hole in the rail .
• Chec k t h e o peration of the slide rails. If they
are hard to move, loosen the screws that secure
them to the center base until they move easily.
This com p l etes the r e p l acement of th e c e n ter base.
Proceed to "Preparing The Drive Chassis."
• U se tw o ¹ 6 x Va " s elf-tapping screws to moun t
t he s l i d e r a i l t o t h e c e n t e r b a s e a s s h o w n ,
T ighten th ese screws u n t i l t h e y ar e j us t s n u g ;
then loosen them 'r~ turn.
PART A
PART B
'~II6 x 5/8"
SELF- TA P P I NG
Istic S C R E W
e6 x 5/8"
® SELF-TA PP I NG
SCREW
SLIDE
©- ~~rg
~ 8 6 x 5/8"
SELF-TAPPING
CREW
SELF-TAPPING
=
tL6 x 5/8"
®
SCREW )
~CI)~
~r
/ / CED
pictorial 4-24
Slide rail installation