Zeiss OPMI PROergo S7, Инструкция по эксплуатации

Страница: 24 / 268

Safety measures S7 / OPMI PROergo
Version 11.0
Page 24 G-30-1435-en
Xenon lighting system
1 Switching to the backup lamp
The lamp module contains two xenon lamps. The second lamp is used as
a backup lamp which has to be swung into the illumination beam path
when the first lamp fails.
• If the xenon lamp fails, open the lamp module as follows:
Press the button (3)

The lamp module will eject partially.
• Pull out the lamp module as far as it will go.
• Turn knob (1) through 180° until it snaps in place. This moves the backup
lamp into the illumination beam path.
• Push the lamp module all the way back into the lamp housing.
2 Indicator: backup lamp is in use
When the segment in knob (1) lights up, the backup lamp is in use.
If the first lamp has failed and the backup lamp is in use, make sure to have
a backup lamp module ready at hand as a precaution.
CAUTION The xenon lamp has a limited service life of 500 h!
If used beyond its maximum service life, the xenon lamp may explode.
• Please replace the xenon lamp in due time.
• Reset the operating time counter.
CAUTION Risk of injury caused by lamp rupture!
Lamp rupture (audible as a loud bang) may lead to jamming of the lamp
module and/or failure of the electronics modules.
• Before opening the lamp housing, ensure that the device is moved to
a position in which possibly falling particles cannot put the patient or user
at risk.
• Do not continue using the system if the lamp module is jammed or the
illumination is no longer operational due to defective electronic modules.
Contact our Service Department.