Zeiss OPMI PROergo S7, Инструкция по эксплуатации, Страница: 22 / 268

Safety measures S7 / OPMI PROergo
Version 11.0
Page 22 G-30-1435-en
– Using the buttons on the handgrip or foot control panel, the surgeon can
then set the illumination intensity to the value required for the procedure.
Please note that the intensity increases with decreasing luminous field size
if the Spot function is used. For this reason, the intensity should only be
set only after the size of the luminous field has been changed.
– Never leave a device unattended when its light source is switched on.
– Switch off the light when the microscope is not in use, and make sure that
it is not aimed at unprotected bare skin.
Please note that most burns affected the skin around the incision. The most
important measures to prevent burns are reduction of the size of the
illuminated field using the spot function and the coverage of peripheral areas
with sterile, moist gauze. The area of the incision should be constantly
moistened.
Concluding remarks
ZEISS recommends that the illumination of the surgical field be kept to the
necessary minimum, for the patient's safety and for a good microscopic
image.
Please refer to the relevant warnings and precautions.