Zeiss OPMI PROergo S7, Инструкция по эксплуатации

Страница: 18 / 268

Safety measures S7 / OPMI PROergo
Version 11.0
Page 18 G-30-1435-en
More specific information about the ceiling mount:
• Move the lift arm or the lifting column down to its lower end position.
• Do not activate the lifting column or the lift arm during surgery. Do not
use the lifting column or the lift arm for focusing.
Specific information about the floor stand:
• Use the grab handle on the floor stand for moving.
• Mind the maximum vertical clearance when passing through doorways.
• Avoid any jolting.
• Risk of toppling – only move the device over steps or raised edges if two
people are available to hold and lift it!
• Be extremely careful when moving over slopes.Be extremely careful when
moving over slopes.
• Do not park the device on sloped surfaces.Do not park the device on
sloped surfaces.
• Secure the device in position by pressing down the immobilizers on the
stand base to prevent the stand from rolling away by itself.
• Do not exceed the instrument tray’s load capacity of 13 kg.
During use
• Never look directly into the light source, e.g. a microscope objective lens
or a light guide, as this might cause phototoxic injury to the eye.
• Never leave a device unattended when its light source is switched on.
• Defective or unidentified accessories may lead to increased leakage
current on the device and injure the patient. Never connect any defective
or unidentified accessories and never touch the power outlet or video
interfaces while in contact with the patient.
• If you replace the lamp shortly after it has failed, the lamp will still be very
hot. Use heat-resistant protective gloves when replacing the lamp to
prevent burns.
• If there is a failure and you cannot get any help from the chapter "What
to do in the event of malfunctions", attach a sign "Out of order" to the
system and contact ZEISS service representative.
• Do not pull at the light guide, power cord or any other connecting cables.