Zeiss OPMI PROergo S7, Инструкция по эксплуатации, Страница: 142 / 268

Preparations for use S7 / OPMI PROergo
Version 11.0
Page 142 G-30-1435-en
Attaching the equipment
Attaching the tube and eyepieces
• Bring the suspension arm in a position convenient for you and firmly
tighten friction adjustment knob (1).
• Loosen securing screw (4) by a few turns.
• Remove cover (3) and store it in a safe place.
• Place the binocular tube (5) on the microscope body and firmly tighten the
securing screw (4).
• Further accessories may be installed between the binocular tube and the
microscope body. Lock these modules in position in the same way using
securing screw (4).
• Insert the widefield eyepieces (7) as far as they will go into their respective
mounts (6). The magnetic coupling reliably secures them in position.
If you wish to use documentation equipment, we can supply an eyepiece with
a reticle to aid focusing. The retrofitting of a reticle to an eyepiece can only
be performed in the factory or by our Service staff. Always install the eyepiece
with the reticle on the same side of the binocular tube where the
documentation equipment is located.
CAUTION Risk of injury from the surgical microscope or its accessories
falling down!
• Never change modules and accessories during a surgical procedure or
above the patient.
• Attach the accessory modules to the microscope and firmly tighten the
respective securing screw.
• Before every use and after re-equipping the instrument, make sure that
the modules are securely locked in position.
• Make sure all the securing screws are firmly tightened!
Mounting and removing modules and accessories may lead to unintended
lowering of the suspension arm.
• Ensure that the maximum permissible load is never exceeded.
• Always re-balance the surgical microscope after re-equipping the system.