Zeiss OPMI Lumera i on floor stand, Инструкция по эксплуатации

Страница: 16 / 178

Version 9.2
Page 16 G-30-1720-en
Safety measures OPMI Lumera
®
i on floor stand
•
Never look at the sun through the binocular tube, the objective lens, or an
eyepiece.
•
The maximum brightness of the lamp(s) can drop over time (normal prop-
erty of device).
Ambient conditions
•
Do not operate the supplied devices under power,
– in explosive atmospheres,
– at a distance of less than 25 cm from flammable anesthetics or volatile
solvents such as alcohol, benzene, or similar substances.
•
Do not store or use this device in damp areas. Do not expose the system
to dripping water, running water, gushing water, sprayed water, or
splashes.
•
Ensure that no liquids can enter the device.
Electrical safety
•
Always switch off the device before you disconnect or connect it from the
electricity network, if you will not be using it for an extended period of
time, or if you want to clean its surface.
•
Switch off the device at the power switch if you notice any smoke, sparks,
or unusual noise. Do not use the device until it has been repaired by the
ZEISS Service team.
A potential equalization connector is provided on the instrument’s connection
panel (see IEC 60601-1). This connector can be used to connect other active
devices to the same ground potential or for redundant connection to the
protective ground.
•
Do not use multiple sockets!
•
Do not remove any parts of the housing! The system contains components
that carry high voltage and may cause electric shock.
•
Do not touch the device if your body is electrostatically charged and the
device is not grounded.
•
Do not pull at the light guide, power cord, or any other connecting cables.
•
Please note the information on EMC (electromagnetic compatibility) in the
section “Device data” on page 150.