Zeiss CONTURA, Руководство по эксплуатации

Страница: 86 / 158

Setting up the workpiece
6-18
61211-1310402 CONTURA
Clamping the workpiece on the measuring table
Workpieces must always be clamped in order to avoid their being
moved, knocked over or falling off of the measuring table. Any un-
clamped workpiece represents a risk to persons, the CMM, and the
workpiece itself.
CAUTION
Risk of injury if an unclamped workpiece falls down.
Crushing and cutting of body parts.
—
Clamp the workpiece on the measuring table before measuring it.
Precautionary measures
Certain safety measures have to be observed to avoid damage to the
CMM and the measuring table.
1 Do not exceed the permissible workpiece weight. See Technical
specifications.
2 Carefully put the workpiece down on the measuring table.
3 Never place the workpiece on the guideway.
The function of the bearings could otherwise be adversely affected.
4 Lift and move heavy workpieces with a lifting device.
—
Approach the CMM slowly in order to avoid damage to the
CMM.
—
Make sure that the workpiece or lifting device does not strike the
CMM. Even light jolts may affect the functioning of the CMM.
—
Lower workpieces of more than 15 kg onto the measuring table
at a maximum speed of 2 mm/s. The CMM may be damaged if
the workpiece is set down abruptly.
5 Put the workpiece down vertically on the measuring table.
6 Do not move the workpiece on the measuring table.