Zeiss CONTURA, Руководство по эксплуатации

Страница: 125 / 158

Malfunctions during measuring operations
61211-1310402 CONTURA
8-3
Malfunctions during measuring operations
The following table helps you identify and eliminate malfunctions that
occur during measuring operations.
NOTE
A malfunction can have different causes. One or more measures may be
necessary to eliminate a certain cause. If two measures are specified,
this does not mean that you have to perform both of them to fix the
problem.
Malfunction Cause Action Check
No travel
movement pos-
sible. The EMERGENCY
STOP button is
locked.
Unlock the button:
– Slightly turn the EMERGENCY
STOP button .
The button pops out
a few millimeters.
Collision, for example
with the workpiece. – Eliminate the cause of the colli-
sion.
– Reactivate the drives.
– Reinitialize the CMM if neces-
sary.
A CNC function has
been activated and is
not yet complete,
e.g. a semi-automatic
measurement run. – Wait until the measurement run
is finished.
The probe is outside
the measuring vol-
ume in the X or Y
axis. Return the probe to the measur-
ing volume.
➤
See more
[
⇨
8-5]
The probe is outside
the measuring vol-
ume in the Z axis. – Release the fall brake and pull
the ram downwards.
➤
See
more [
⇨
8-5]
Pressure is too low. – Increase the pressure in the
supply line. Pressure gauges
The filter is clogged. – Change the filter.
Air noise from
the air bear-
ings. The pressure is too
high. – Reduce the pressure in the air
supply line.
– Call a ZEISS service engineer.
Pressure gauges