Zeiss 000000-1080-349, Инструкция по эксплуатации

Страница: 224 / 278

Care and Maintenance S100 / OPMI pico
Version 7.0
Page 224 G-30-1781-en
Replacing the halogen lamp
• Only use the halogen light indicated in chapter "Device data => order da-
ta".
• Turn off the suspension system at the power switch.
• Press button (3), the lamp module is slightly ejected. Pull out lamp module
(2).
• Press the button (1). The lamp holder in the lamp module springs open.
• Remove the defective halogen lamp from the spring-loaded mount.
• Pull the ceramic base (9) from the contact pins of the halogen lamp.
Make sure not to touch the bulb (8) or the inner side of the lamp reflector (7)
of the new halogen lamp.
• Plug ceramic base (9) onto the contact pins of a new halogen lamp.
• Insert the new halogen lamp.
• Press the halogen lamp into the spring-loaded mount.
• Press the lamp holder (5) into the lamp module until it snaps in.
• Push the lamp module including the new halogen lamp back into the sys-
tem.
• Turn on the system at its power switch.
• Use the brightness control to adjust the illumination when the suspension
arm is in its working position.
NOTE Risk of burns caused by hot lamps!
If you change the lamp shortly after it has failed, the lamp will still be very
hot.
• Allow the lamp to cool down before changing it.