7 / 58
Identificazione: MD-AL-GI-00
Rev. 4.0 del 31.01.18 - Applicazione: GID
Manual of 11/06/2019 Rev. 1.8 “User Manual for 3000SP storage inverter”
2.
Preliminary safety instructions
Before installation, please read this manual carefully and make sure you fully understand its contents. The
3000SP inverter strictly complies with the safety, design and testing regulations provided for by the national
standards.
During installation, operation and maintenance, operators must carefully observe the local safety standards.
Improper use may result in electrical shock and harm and damage to persons, the equipment and its
components.
Contact the nearest authorised service centre for any repairs or maintenance. Contact your distributor for
information on the nearest authorised service centre. DO NOT carry out repairs yourself, as this may result
in injury or damage.
Ensure that the operator has the necessary skills and training to operate the equipment. Personnel
responsible for the use and maintenance of the equipment must be qualified and capable of performing the
activities described, and must also have appropriate knowledge on how to correctly interpret the contents of
this manual. For safety reasons, this inverter can only be installed by a qualified electrician with the
necessary training and/or skills and knowledge. Zucchetti Centro Sistemi S.p.A. declines all responsibility for
damage to property or personal injury caused by incorrect use of the device.
Install and start the inverter according to the following instructions. Place the inverter on suitable load-
bearing supports with sufficient load capacity (such as walls or racks) and make sure that the inverter is
positioned vertically. Choose a suitable location for the installation of the electrical equipment. Make sure
there is sufficient space for heat dispersion and to accommodate future maintenance. Maintain adequate
ventilation and ensure that there is enough air circulation for cooling.
If you have problems with the packaging that could damage the inverter or if you find any visible damage,
immediately notify the transport company. If necessary, request assistance from an installer of photovoltaic
systems or from Zucchetti Centro Sistemi SpA. Transport of the equipment, especially by road, must be
carried out with vehicles suitable to protect the components (in particular, electronic components) against
violent knocks, humidity, vibrations, etc.
2.1.
General safety instructions
Installation and maintenance of the system must be carried out by qualified and certified electricians
in compliance with national regulations.
The 3000SP inverter must only be installed by qualified personnel and only after obtaining the
appropriate authorisations and permits as required by the local regulations.
DO NOT place explosives or flammable materials (e.g. gasoline, kerosene, oil, wood, cotton or similar)
near the batteries or the 3000SP inverter.
Before any maintenance, disconnect the DC (battery) and AC (grid and loads) connections, then wait
at least 5 minutes to allow the capacitors to discharge and to prevent accidental electrical discharges.
The 3000SP inverter must be completed disconnected (DC and AC side) during maintenance.
The 3000SP inverter may reach high temperatures during operation. Switch off the inverter and wait
for it to cool down before maintenance.
Keep children away from the batteries and inverter.
Do not open the front cover of the inverter. This will void the product warranty.
