35 / 58
Identificazione: MD-AL-GI-00
Rev. 4.0 del 31.01.18 - Applicazione: GID
Manual of 11/06/2019 Rev. 1.8 “User Manual for 3000SP storage inverter”
When setting this parameter for Pylontech batteries, refer to the table in section 6.2; for
different battery models, refer to the relative datasheet.
7)
Maximum discharge current (A)
Select “7. Max discharge current (A)” and press “OK” to enter the menu for setting the
maximum discharge current. Press the “Up” and “Down” keys to change the value of the
maximum discharge current. Press “OK” to move to the next digit and then confirm the setting;
wait for “OK” to appear on the display.
When setting this parameter for Pylontech batteries, refer to the table in section 6.2; for
different battery models, refer to the relative datasheet.
8)
Minimum voltage threshold (only for DEFAULT batteries)
Select “8. Min voltage threshold” and press “OK” to enter the menu for setting the protection
voltage for low voltage. Press the “Up” and “Down” keys to change the value of the protection
voltage for low voltage. Press “OK” to move to the next digit and then confirm the setting; wait
for “OK” to appear on the display.
When setting this parameter, refer to the relative datasheet of the battery used.
9)
Minimum discharge voltage
Select “9. Min Discharge Voltage (V)” and press “OK” to enter the menu for setting the
minimum discharge voltage. Press the “Up” and “Down” keys to change the value of the
minimum discharge voltage. Press “OK” to move to the next digit and then confirm the setting;
wait for “OK” to appear on the display.
When setting this parameter for Pylontech batteries, refer to the table in section 6.2; for
different battery models, refer to the relative datasheet.
10)
End-of-discharge voltage (only for DEFAULT batteries)
Select “11. End-of-discharge V” and press “OK” to enter the menu for setting the end-of-
discharge voltage. Press the “Up” and “Down” keys to change the value. Press “OK” to move to
the next digit and then confirm the setting; wait for “OK” to appear on the display.
When setting this parameter, refer to the relative datasheet of the battery used.
Note: This setting is very important for lead-acid batteries, while it is not so important for
lithium batteries with BMS.
11)
End-of-charge Voltage (only for DEFAULT batteries)
Select “11. End-of-charge V” and press “OK” to enter the menu for setting the end-of-charge
voltage. Press the “Up” and “Down” keys to change the value. Press “OK” to move to the next
digit and then confirm the setting; wait for “OK” to appear on the display.
When setting this parameter, refer to the relative datasheet of the battery used.
Note: This setting is very important for lead-acid batteries, while it is not so important for
lithium batteries with BMS.
12)
Save
Select “Save” and press “OK” to save all the settings.
