Yealink SIP-T19 E2 T4 Series, Руководство администратора

Страница: 666 / 981

Administrator’s Guide for SIP-T2 Series/T19(P) E2/T4 Series/T5 Series IP Phones
644
Variable Value Phone Action
AlwaysFwdOn/BusyFwdOn/NoAnswF
wdOn=xxx=n
Activate an always/busy/no answer forward
feature to xxx for the IP phone (“xxx” means the
destination number)
The valid value of “n” means the duration time
(seconds) before forwarding incoming calls (n
is the times of 6, for example, 24). It is only
applicable to no answer forward feature.
Note
: For Yealink IP phones, it works only if the
value of the parameter “features.fwd.allow” is
set to 1 (Enabled) and call forward mode is
Phone, the always/busy/no answer forward
feature will apply to all the accounts on the
phone.
Example
:
http://10.10.20.10/servlet?key=NoAnswFwdOn
=1001=24
AlwaysFwdOff/BusyFwdOff/NoAnswF
wdOff
Deactivate the always/busy/no answer forward
feature for the IP phone.
Note
: For Yealink IP phones, it works only if the
value of the parameter “features.fwd.allow” is
set to 1 (Enabled) and call forward mode is
Phone, the always/busy/no answer forward
feature will apply to all the accounts on the
phone.
Example
:
http://10.10.20.10/servlet?key=NoAnswFwdOff
CALLEND/CallEnd End a call.
ASW/CANCEL/HOLD/UNHOLD:xxx
Answer/end/hold/unhold a call (xxx refers to
the call-id of the active call).
Example
:
http://10.10.20.10/servlet?key=ASW:33093
Note
: To get the call-id of the active call,
configure the action URL:
http(s)://<phoneIPAddress>/help.xml?CallId=$
call_id
. For more information, refer to Action
URL on page 622 .
Note
The variable value is not applicable to all events. For example, the variable value “MUTE” is only
applicable when the IP phone is during a call.
When authentication is required, you can use the following URI format:
http(s)://username:password@<phoneIPAddress>/servlet?key=variable value
or
http(s)://<phoneIPAddress>/servlet?key=variable value&@username:password
.