Yamaha Tenere 700 2020, Руководство по обслуживанию

Страница: 360 / 472

FUEL INJECTION SYSTEM
8-49
Fault code No. P0132
5 Installed condition of throttle po-
sition sensor. Check for looseness or pinch-
ing.
Improperly installed sensor
→
Reinstall or adjust the sensor.
Refer to “ADJUSTING THE
THROTTLE POSITION SEN-
SOR” on page 7-11.
Turn the main switch to “ON”,
and then check the condition of
the fault code using the mal-
function mode of the Yamaha di-
agnostic tool.
Condition is “Recover”
→
Go to
item 9 and finish the service.
Condition is “Malfunction”
→
Go
to item 6.
6 Throttle position sensor resis-
tance. Measure the throttle position
sensor resistance.
black/blue–blue
Refer to “CHECKING THE
THROTTLE POSITION SEN-
SOR” on page 8-138. Turn the main switch to “ON”,
and then check the condition of
the fault code using the mal-
function mode of the Yamaha di-
agnostic tool.
Condition is “Recover”
→
Go to
item 9 and finish the service.
Condition is “Malfunction”
→
Go
to item 7.
7 Defective throttle position sen-
sor. Check throttle position sensor
signal.
Execute the diagnostic mode.
(Code No. 01)
When the throttle valves are ful-
ly closed:
A value of 11–21 is indicated.
When throttle valves are fully
open:
A value of 96–106 is indicated. Turn the main switch to “ON”,
and then check the condition of
the fault code using the mal-
function mode of the Yamaha di-
agnostic tool.
Condition is “Recover”
→
Go to
item 9 and finish the service.
Condition is “Malfunction”
→
Go
to item 8.
8 Malfunction in ECU. Replace the ECU.
Refer to “REPLACING THE
ECU (engine control unit)” on
page 8-130. Service is finished.
9 Delete the fault code and check
that the engine trouble warning
light goes off. Confirm that the fault code has
a condition of “Recover” using
the Yamaha diagnostic tool, and
then delete the fault code.
Fault code No. P0132
Item O
2
sensor: short circuit detected (power short circuit).
Fail-safe system
Able to start engine
Able to drive vehicle
Diagnostic code No. —
Tool display —
Procedure —
Item
Probable cause of malfunc-
tion and check
Maintenance job
Confirmation of service com-
pletion