Yamaha Tenere 700 2020, Руководство по обслуживанию

Страница: 131 / 472

FRONT BRAKE
4-32
EAS30173
CHECKING THE FRONT BRAKE CALIPERS
The following procedure applies to both of the
brake calipers.
1. Check:
• Brake caliper body
Cracks/damage
→
Replace the brake caliper
assembly.
• Brake fluid delivery passages
(brake caliper body)
Obstruction
→
Blow out with compressed air.
EAS30175
INSTALLING THE FRONT BRAKE CALIPERS
The following procedure applies to both of the
brake calipers.
1. Install:
• Front brake caliper
(temporarily)
• Brake hose gaskets
• Brake hose (hydraulic unit to right front brake
caliper)
• Brake hose (right front brake caliper to left
front brake caliper)
• Brake hose union bolt
WARNING
EWA13531
Proper brake hose routing is essential to in-
sure safe vehicle operation.
TIP
• There should be 1.5–2.5 mm (0.06–0.10 in)
clearance between the brake pipe and brake
caliper as shown in the illustration.
• Align the pins “b” of the brake hose (hydraulic
unit to right front brake) and brake hose (right
front brake caliper to left brake caliper).
2. Remove:
• Front brake caliper
3. Install:
• Brake pad spring
• Brake pads
• Brake pad pin
• Brake pad clips
Refer to “REPLACING THE FRONT BRAKE
PADS” on page 4-30.
4. Fill:
• Brake master cylinder reservoir
(with the specified amount of the specified
brake fluid)
WARNING
EWA13090
• Use only the designated brake fluid. Other
brake fluids may cause the rubber seals to
deteriorate, causing leakage and poor
brake performance.
• Refill with the same type of brake fluid that
is already in the system. Mixing brake fluids
may result in a harmful chemical reaction,
leading to poor brake performance.
Recommended brake component
replacement schedule
Brake pads If necessary
Brake hoses Every four years
Brake fluid
Every two years and
whenever the brake is
disassembled
T
R
.
.
Front brake hose union bolt
30 N·m (3.0 kgf·m, 22 lb·ft)
New
A. Left side
B. Right side
a. 1.5–2.5 mm (0.059–0.098 in)
Specified brake fluid
DOT 4
a a
A B
b