Yamaha Tenere 700 2020, Руководство по обслуживанию

Страница: 361 / 472

FUEL INJECTION SYSTEM
8-50
1 Installed condition of O
2
sensor. Check for looseness or pinch-
ing.
Improperly installed sensor
→
Reinstall or replace the sensor.
Turn the main switch to “ON”,
and then check the condition of
the fault code using the mal-
function mode of the Yamaha di-
agnostic tool.
Condition is “Recover”
→
Go to
item 7 and finish the service.
Condition is “Malfunction”
→
Go
to item 2.
2 Connection of O
2
sensor cou-
pler.
Check the locking condition of
the coupler.
Disconnect the coupler and
check the pins (bent or broken
terminals and locking condition
of the pins).
Improperly connected
→
Con-
nect the coupler securely or re-
place the wire harness.
Turn the main switch to “ON”,
and then check the condition of
the fault code using the mal-
function mode of the Yamaha di-
agnostic tool.
Condition is “Recover”
→
Go to
item 7 and finish the service.
Condition is “Malfunction”
→
Go
to item 3.
3 Connection of wire harness
ECU coupler.
Check the locking condition of
the coupler.
Disconnect the coupler and
check the pins (bent or broken
terminals and locking condition
of the pins). Improperly connected
→
Con-
nect the coupler securely or re-
place the wire harness.
Turn the main switch to “ON”,
and then check the condition of
the fault code using the mal-
function mode of the Yamaha di-
agnostic tool.
Condition is “Recover”
→
Go to
item 7 and finish the service.
Condition is “Malfunction”
→
Go
to item 4.
4 Wire harness continuity. Open or short circuit
→
Properly
connect or replace the wire har-
ness.
Between ECU coupler and O
2
sensor coupler.
gray/green-gray/green
Between O
2
sensor coupler and
joint coupler.
black/blue-black/blue
Between joint coupler and ECU
coupler.
black/blue-black/blue
Turn the main switch to “ON”,
and then check the condition of
the fault code using the mal-
function mode of the Yamaha di-
agnostic tool.
Condition is “Recover”
→
Go to
item 7 and finish the service.
Condition is “Malfunction”
→
Go
to item 5.
5 Defective O
2
sensor. Check the O
2
sensor.
Defective
→
Replace the O
2
sensor.
Refer to “ENGINE REMOVAL”
on page 5-3.
Turn the main switch to “ON”,
and then check the condition of
the fault code using the mal-
function mode of the Yamaha di-
agnostic tool.
Condition is “Recover”
→
Go to
item 7 and finish the service.
Condition is “Malfunction”
→
Go
to item 6.
6 Malfunction in ECU. Replace the ECU.
Refer to “REPLACING THE
ECU (engine control unit)” on
page 8-130. Service is finished
7 Delete the fault code and check
that the engine trouble warning
light goes off. Confirm that the fault code has
a condition of “Recover” using
the Yamaha diagnostic tool, and
then delete the fault code.