Yamaha Tenere 700 2020, Руководство по обслуживанию

Страница: 236 / 472

CLUTCH
5-49
TIP
• Apply lithium-soap-based grease onto the pull
rod.
• Tighten the clutch spring bolts in stages and in
a crisscross pattern.
5. Install:
• Bearings “1”
• Oil seal “2”
(to the clutch cover)
TIP
• Lubricate the bearings with engine oil and lubri-
cate the oil seal with lithium-soap-based
grease.
• Install the bearings until they contact the sur-
faces “a” and install the oil seal until it contacts
the surface “b” as shown in the illustration.
6. Install:
• Dowel pins
• Clutch cover gasket
• Clutch cover
• Pull lever shaft cover
• Clutch cable holder
TIP
• Align the slit “a” in the impeller shaft with the
projection “b” on the oil pump driven sprocket.
• Face the serrations on the clutch pull rod “1”
rearward and align the rod with the hole “c” in
the clutch cover.
• Make sure that the pull rod teeth and pull lever
shaft pinion gear are engaged.
• Tighten the bolts in stages and in a crisscross
pattern.
7. Install:
• Pull lever
TIP
• Install the pull lever with the “UP” mark “a” fac-
ing toward upper side.
• When installing the pull lever, push the pull le-
ver and check that the punch mark “b” on the
pull lever aligns with the mark “c” on the pull le-
ver shaft cover.
8. Connect:
• Clutch cable
TIP
• Install the clutch cable so that the clutch cable
length “a” is 51.6–62.2 mm (2.03–2.45 in) as
shown in the illustration.
T
R
.
.
Clutch spring bolt
8 N·m (0.8 kgf·m, 5.9 lb·ft)
New
2
1
a
a
b 1
New
New
T
R
.
.
Clutch cover bolt
12 N·m (1.2 kgf·m, 8.9 lb·ft)
Clutch cable holder bolt
12 N·m (1.2 kgf·m, 8.9 lb·ft)
LOCTITE®
c
a
b
1
LS
a
c
b