Yamaha Tenere 700 2020, Руководство по обслуживанию

Страница: 366 / 472

FUEL INJECTION SYSTEM
8-55
1 Connection of cylinder-#1 igni-
tion coil coupler.
Check the locking condition of
the coupler.
Disconnect the coupler and
check the pins (bent or broken
terminals and locking condition
of the pins). Improperly connected
→
Con-
nect the coupler securely or re-
place the wire harness.
Start the engine and let it idle for
approximately 5 seconds.
Check the condition of the fault
code using the malfunction
mode of the Yamaha diagnostic
tool.
Condition is “Recover”
→
Go to
item 7 and finish the service.
Condition is “Malfunction”
→
Go
to item 2.
2 Connection of ECU coupler.
Check the locking condition of
the coupler.
Disconnect the coupler and
check the pins (bent or broken
terminals and locking condition
of the pins). Improperly connected
→
Con-
nect the coupler securely or re-
place the wire harness.
Start the engine and let it idle for
approximately 5 seconds.
Check the condition of the fault
code using the malfunction
mode of the Yamaha diagnostic
tool.
Condition is “Recover”
→
Go to
item 7 and finish the service.
Condition is “Malfunction”
→
Go
to item 3.
3 Wire harness continuity. Open or short circuit
→
Replace
the wire harness.
Between cylinder-#1 ignition coil
coupler and ECU coupler.
orange–orange
Start the engine and let it idle for
approximately 5 seconds.
Check the condition of the fault
code using the malfunction
mode of the Yamaha diagnostic
tool.
Condition is “Recover”
→
Go to
item 7 and finish the service.
Condition is “Malfunction”
→
Go
to item 4.
4 Installed condition of cylinder-#1
ignition coil. Check for looseness or pinch-
ing.
Improperly installed ignition coil
→
Reinstall or replace the igni-
tion coil.
Start the engine and let it idle for
approximately 5 seconds.
Check the condition of the fault
code using the malfunction
mode of the Yamaha diagnostic
tool.
Condition is “Recover”
→
Go to
item 7 and finish the service.
Condition is “Malfunction”
→
Go
to item 5.
5 Defective cylinder-#1 ignition
coil. Measure the primary coil resis-
tance of the cylinder-#1 ignition
coil.
Replace if out of specification.
Refer to “CHECKING THE IG-
NITION COILS” on page 8-134. Start the engine and let it idle for
approximately 5 seconds.
Check the condition of the fault
code using the malfunction
mode of the Yamaha diagnostic
tool.
Condition is “Recover”
→
Go to
item 7 and finish the service.
Condition is “Malfunction”
→
Go
to item 6.
6 Malfunction in ECU. Execute the diagnostic mode.
(Code No. 30)
No spark
→
Replace the ECU.
Refer to “REPLACING THE
ECU (engine control unit)” on
page 8-130.
Service is finished.