Yamaha Tenere 700 2020, Руководство по обслуживанию

Страница: 183 / 472

CHAIN DRIVE
4-84
EAS30234
INSTALLING THE DRIVE CHAIN
1. Install:
• Drive chain
2. Lubricate:
• Drive chain
3. Install:
• Shift arm “1”
• Shift rod joint
• Shift rod
• Shift rod locknuts
TIP
Before installing, make sure to align the mark “a”
of the shift shaft with the mark “b” of the shift
arm.
4. Measure:
• Installed shift rod length “a” and “b”
Incorrect
→
Adjust.
5. Adjust:
• Installed shift rod length
a. Loosen both locknuts “1”.
TIP
The shift rod locknut (shift pedal side) has left-
hand threads.
b. Turn the shift rod “2” to obtain the correct
shift pedal position.
c. Tighten both locknuts.
d. Make sure that the angle between the shift
arm and the shift rod is about 90°.
6. Adjust:
• Drive chain slack
Refer to“ADJUSTING THE DRIVE CHAIN
SLACK” on page 3-18.
Recommended lubricant
Chain lubricant suitable for O-
ring chains
T
R
.
.
Shift arm pinch bolt
14 N·m (1.4 kgf·m, 10 lb·ft)
Installed length “a”
273–275 mm (10.7–10.8 in)
Installed length “b”
35–36 mm (1.38–1.42 in)
1
a
2
b
New
1
b a
T
R
.
.
Shift rod locknut (shift arm side)
9 N·m (0.9 kgf·m, 6.6 lb·ft)
Shift rod locknut (shift pedal
side)
9 N·m (0.9 kgf·m, 6.6 lb·ft)
Left-hand threads
a
b
1
2
90°