Yamaha Tenere 700 2020, Руководство по обслуживанию

Страница: 378 / 472

FUEL INJECTION SYSTEM
8-67
Fault code No. P0511
B-8 Malfunction in ECU. Replace the ECU.
Refer to “REPLACING THE
ECU (engine control unit)” on
page 8-130. Service is finished.
B-9 Delete the fault code and check
that the engine trouble warning
light goes off. Start the engine and let it idle for
approximately 10 seconds.
Confirm that the fault code has
a condition of “Recover” using
the malfunction mode of the
Yamaha diagnostic tool, and
then delete the fault code.
Fault code No. P0511
Item ISC unit: malfunction in ISC unit.
Fail-safe system
Able to start engine
Able to drive vehicle
Diagnostic code No. —
Tool display —
Procedure —
Item
Probable cause of malfunc-
tion and check
Maintenance job
Confirmation of service com-
pletion
1 Connection of ISC unit coupler.
Check the locking condition of
the coupler.
Disconnect the coupler and
check the pins (bent or broken
terminals and locking condition
of the pins). Improperly connected
→
Con-
nect the coupler securely or re-
place the sub-wire harness.
Turn the main switch to “ON”,
and then check the condition of
the fault code using the mal-
function mode of the Yamaha di-
agnostic tool.
Condition is “Recover”
→
Go to
item 7 and finish the service.
Condition is “Malfunction”
→
Go
to item 2.
2 Connection of sub-wire har-
ness coupler.
Check the locking condition of
the coupler.
Disconnect the coupler and
check the pins (bent or broken
terminals and locking condition
of the pins). Improperly connected
→
Con-
nect the coupler securely or re-
place the sub-wire harness.
Turn the main switch to “ON”,
and then check the condition of
the fault code using the mal-
function mode of the Yamaha di-
agnostic tool.
Condition is “Recover”
→
Go to
item 7 and finish the service.
Condition is “Malfunction”
→
Go
to item 3.
3 Connection of ECU coupler.
Check the locking condition of
the coupler.
Disconnect the coupler and
check the pins (bent or broken
terminals and locking condition
of the pins). Improperly connected
→
Con-
nect the coupler securely or re-
place the wire harness.
Turn the main switch to “ON”,
and then check the condition of
the fault code using the mal-
function mode of the Yamaha di-
agnostic tool.
Condition is “Recover”
→
Go to
item 7 and finish the service.
Condition is “Malfunction”
→
Go
to item 4.