Yamaha Tenere 700 2020, Руководство по обслуживанию

Страница: 87 / 472

PERIODIC MAINTENANCE
3-22
TIP
Although the total number of clicks of a damping
force adjusting mechanism may not exactly
match the above specifications due to small dif-
ferences in production, the actual number of
clicks always represents the entire adjusting
range. To obtain a precise adjustment, it would
be advisable to check the number of clicks of
each damping force adjusting mechanism and
to modify the specifications as necessary.
Bleeding the front fork
1. Place the motorcycle on a suitable stand.
2. Make sure the front wheel is off the ground
and the area near the bleed screws is clean.
3. Remove:
• Bleed screw “1”
4. Wait a few seconds, and then install the bleed
screws.
EAS30808
CHECKING THE REAR SHOCK ABSORBER
ASSEMBLY
Refer to “CHECKING THE REAR SHOCK AB-
SORBER ASSEMBLY” on page 4-73.
EAS30655
ADJUSTING THE REAR SHOCK ABSORBER
ASSEMBLY
WARNING
EWA13120
Securely support the vehicle so that there is
no danger of it falling over.
Spring preload
NOTICE
ECA13590
Never go beyond the maximum or minimum
adjustment positions.
1. Adjust:
• Spring preload
a. Turn the adjusting knob “1” in direction “a”
or “b”.
Direction “a”
Compression damping is increased
(suspension is harder).
Direction “b”
Compression damping is decreased
(suspension is softer).
Compression damping
Adjustment value from the start
position (Soft)
22
Adjustment value from the start
position (STD)
11
Adjustment value from the start
position (Hard)
0
* With the adjusting screw fully turned in
direction “a”
1
b
a
1
b
a
Direction “a”
Spring preload is increased (suspen-
sion is harder).
Direction “b”
Spring preload is decreased (suspen-
sion is softer).
Spring preload
Adjustment value (Soft)
0
Adjustment value (STD)
10
Adjustment value (Hard)
24
* With the adjusting knob fully turned in di-
rection “b”
1