Yamaha Tenere 700 2020, Руководство по обслуживанию

Страница: 122 / 472

REAR WHEEL
4-23
NOTICE
ECA21011
• Do not drop the wheel sensor rotor or sub-
ject it to shocks.
• If any solvent gets on the wheel sensor ro-
tor, wipe it off immediately.
• Replace the brake disc bolts and wheel
sensor rotor bolts with new ones.
TIP
• Install the wheel sensor rotor with the stamped
mark “a” facing outward.
• Tighten the brake disc bolts and wheel sensor
rotor bolts in stages and in a crisscross pattern.
• Tighten the rear brake disc bolt as illustration.
2. Install:
• Rear wheel sprocket
Refer to “CHECKING AND REPLACING
THE REAR WHEEL SPROCKET” on page
4-21.
3. Check:
• Rear brake disc
Refer to “CHECKING THE REAR BRAKE
DISC” on page 4-40.
4. Lubricate:
• Oil seal lips
5. Install:
• Collar (right)
• Collar (left)
• Rear brake caliper “1”
• Rear wheel
• Adjusting blocks
• Rear wheel axle
• Washer
• Rear wheel axle nut
TIP
• Install the rear wheel with the mark “a” on the
rear tire pointing in the direction of wheel rota-
tion.
• Align the projection “b” in the swingarm with the
slot “c” of the brake caliper bracket.
6. Install:
• Rear wheel sensor lead holder “1”
TIP
Contact the rear wheel sensor lead holder to the
caliper bracket.
T
R
.
.
Rear wheel sensor rotor bolt
8 N·m (0.8 kgf·m, 5.9 lb·ft)
LOCTITE®
Rear brake disc bolt
30 N·m (3.0 kgf·m, 22 lb·ft)
LOCTITE®
a
1
3
5
4
2
Recommended lubricant
Lithium-soap-based grease
T
R
.
.
Rear wheel sensor lead holder
bolt
7 N·m (0.7 kgf·m, 5.2 lb·ft)
a
b
c
1