Yamaha Tenere 700 2020, Руководство по обслуживанию

Страница: 153 / 472

HANDLEBAR
4-54
EAS30203
REMOVING THE HANDLEBAR
1. Stand the vehicle on a level surface.
WARNING
EWA13120
Securely support the vehicle so that there is
no danger of it falling over.
2. Remove:
• Handlebar grip “1”
TIP
Blow compressed air between the left handlebar
and the handlebar grip, and gradually push the
grip off the handlebar.
3. Remove:
• Throttle cable housings
TIP
While removing the throttle cable housing, pull
back the rubber cover “1”.
EAS30204
CHECKING THE HANDLEBAR
1. Check:
• Handlebar
Bends/cracks/damage
→
Replace.
WARNING
EWA13690
Do not attempt to straighten a bent handle-
bar as this may dangerously weaken it.
EAS30205
INSTALLING THE HANDLEBAR
1. Stand the vehicle on a level surface.
WARNING
EWA13120
Securely support the vehicle so that there is
no danger of it falling over.
2. Install:
• Lower handlebar holder “1”
• Handlebar “2”
• Upper handlebar holder “3”
NOTICE
ECA19130
• First, tighten the bolts on the front side of
the upper handlebar holder, and then on
the rear side.
• Turn the handlebar all the way to the left
and right. If there is any contact with the
fuel tank, adjust the handlebar position.
TIP
• The lower handlebar holder should be installed
with the projections “a” facing rearward.
• Align the punch mark “b” on the handlebar with
the right inner side of the lower handlebar hold-
er.
• The upper handlebar holders should be in-
stalled with the punch marks “c” facing forward.
3. Install:
• Front brake master cylinder
Refer to “INSTALLING THE FRONT BRAKE
MASTER CYLINDER” on page 4-33.
4. Install:
• Throttle grip
• Throttle cables
• Throttle cable housing “1”
1
G088916
1
T
R
.
.
Lower handlebar holder nut
32 N·m (3.2 kgf·m, 24 lb·ft)
Upper handlebar holder bolt
28 N·m (2.8 kgf·m, 21 lb·ft)
c
b
c
3
2
1
a
a