Xo FLEX, Инструкция по эксплуатации, Страница: 50 / 95

XO FLEX – Instructions for use
Configuration
50
4. Activate
►
to select the parameter to change
5. Use
▲
/
▼
to change the value of the selected parameter or ⬇ to increase the value
6. Activate
◄
to save the new parameter
7. If an additional instrument parameter is to be configured, use
▲
/
▼
until the display shows
the parameter in question
8. Place the instrument on the bridge again
Table 6 – Unit instrument parameters that can be configured
Parameter Display text Factory default
configuration Possible settings
Bien-Air MC3 / MX2 micro motor
Maximum speed
4
–
Level 3
LEVEL 3 40,000 RPM 100 – 40,000 + 10% RPM
Maximum speed – Level
2 LEVEL 2 10,000 RPM 100 – 40,000 + 10% RPM
Maximum speed – Level
1 LEVEL 1 4.000 RPM 100 – 40,000 + 10% RPM
Amount of spray water –
Level 3 W LEVEL 3 Without contra-
angle (what you see
on the display): 100
ml/min
With contra-angle:
approximately 70
ml/min Without contra-angle: 10 –
100 ml/min
Amount of spray water –
Level 2 W LEVEL 2 Without contra-
angle (what you see
on the display): 50
ml/min
With contra-angle:
approximately 50
ml/min Without contra-angle: 10 –
100 ml/min
Amount of spray water –
Level 1 W LEVEL 1 Without contra-
angle (what you see
on the display): 35
ml/min
With contra-angle:
approximately 35
ml/min Without contra-angle: 10 –
100 ml/min
Amount of spray air AIR 70% 0 – 100%
Automatic chip blow CHIP Enabled Enabled, Disabled
Spray selection 4 STATES Disabled Enabled, Disabled
XO OSSEO motor
Maximum speed
5
–
Level 3
LEVEL 3 40,000 RPM 100 – 40,000 + 10% RPM
Maximum speed – Level
2 LEVEL 2 16,000 RPM 100 – 40,000 + 10% RPM
Maximum speed – Level
1 LEVEL 1 300 RPM 100 – 40,000 + 10% RPM
4 Please note that it is the speed of the micromotor itself. When you fit a contra-angle the speed of the bur may be changed!
5 Please note that it is the speed of the micromotor itself. When you fit a contra-angle the speed of the bur may be changed!