Xante FilmMaker 4, Руководство пользователя

Страница: 166 / 310

3-54 PC Setup
3. Check and adjust the PostScript margins if necessary.
a. Click Update/Print. An alignment test page prints (fig. 3.112).
-x
-y
Alignment test page Current settings:
x =0, y =0
Fig. 3.112 Sample Alignment Test Page
b. Turn the test page so that the -x is to the left and the -y is at the top of the
crossed lines.
c. Check the current settings listed on the test page. The factory default is
x=0, y=0, which should cause each line to print 1" (25.4 mm) from the
page’s edges.
Coordinates listed on the alignment test page indicate change from the
factory default in dots per inch. Because these measurements are rounded
for display, adjustments should b based on careful measurements, not the
printed coordinates.
If current settings are not the factory defaults and you must adjust the coordinates,
you may reset factory default coordinates by selecting Reset Margins and clicking
Update. Print another alignment test page using the factory defaults, measure the
lines, and make adjustments if necessary.
d. Measure the distance from the edge of the page to the -x line; it should
measure 1" (25.4 mm). This distance is dependent on the y coordinate. If
an adjustment needs to be made, use the following appropriate
procedure.
• To move the -x line away from the edge of the page, select an
appropriate plus value in the X-Coordinate field.
• To move the -x line closer to the edge of the page, select an
appropriate minus value in the X-Coordinate field.