32
Flex Fuel Owner’s Manual
March 2011
9.11 Hour Meter
T
he following operating hours are also logged:
• Feed runtime (in hours)
• Lambda sensor heating time (in hours)
• Induced draft fan runtime, during which the furnace operating mode was set to pellets (in hours)
• Induced draft fan runtime, during which the furnace operating mode was set to either Bulk materials
or Bulk materials - automatic (in hours)
• Secondary air motor runtime (in hours)
• Igniter runtime (in hours)
• Heat exchanger cleaning runtime (in hours)
• Furnace runtime during which the Operating status was "Bulk materials!" (in hours)
• Furnace runtime during which the Operating status was "Bulk materials! Part load mode!" (in hours)
• Furnace runtime during which the Operating status was "Pellets mode!" (in hours)
• Number of furnace starts (applies to furnace operating modes "Bulk materials" or "Bulk materials -
automatic") The counter always increases by 1 if the operating status changes either from “Please
ignite!” to “Bulk materials!” (for furnace operating mode “Bulk materials” or from “Automatic ignition!” to
“Bulk materials!” (for furnace operating mode “Bulk materials - automatic”)
• Number of furnace starts (applies to furnace operating mode “Pellets” ”) The counter is always
increased by 1, if the operating status changes from “Ignition phase!” to “Start phase”
9: Basic Furnace Settings
Feed:
Lambda sensor:
Ind. dr.fan PE/SM:
Ind. draft fan BM:
Vacuum turbine:
Second. air motor:
Ignition:
Heat exchanger:
Storage room:
“Bulk materials!”:
“BM part load”:
“Pellet mode!”:
Starts BM:
Starts PE/BM:
8
6
12
0
^^^^^^
0
0
0
^^^^^^
0
0
0
42
9
OPERATING HOUR COUNTER
