Wohler AMP2-16V-M, Руководство пользователя

Страница: 47 / 172

Page 40
How Do I Set Up a SuperPair to Monitor Intercom or Other
Sources?
A SuperPair is a 9th audio input pair that you can monitor along with the normally
monitored audio channels. It can be any input pair. This special pair can be heard in
the speakers or outputs, but is not metered on the Main Screen. It is useful if you
need to hear production intercom audio (or any other audio) along with the
monitored audio.
If you need a front panel volume control to adjust the SuperPair, please refer to
How Do I Set Up a SuperPair Volume Control? in this chapter.
This setup is done in the
Monitor Mixer Configuration Menu
:
Configuration Selection
Menu
Main Screen
Menu
Configure
Monitor Mixer
Monitor Mixer
Configuration Menu
Figure 3–19: Monitor Mixer Configuration Menu
Monitor Mixer Configuration Menu
Save / Exit Help Cancel
Chan 1 Chan 2 Chan 3 Chan 4
Slot 2 SDI-3G In
Pair 4
Slot 2 SDI-3G In
Pair 5
+0 +0 +0 +0
Channel
Trim
Source
Pair
Select
Phase
LED
On/Off
Delay to Speakers = 170 mS
Audio
Delay
Dolby 5.1
Speaker
Mute:
Off
L Front R Front Center LFE
Channel
Func
Mixer
Channel
Select
Set
Clusters
1. Rotate the Mixer Channel Select to select the 9th channel pair, the
SuperPair.
2. Rotate the Source Pair Select to select the audio processor card slot and
desired input pair on that card.
3. You may want to adjust the Channel Trim control to increase or decrease
the desired input gain, relative to the other channel audio levels. Turn the
Mixer Channel Select knob to the channel you want to adjust and then turn
the Channel Trim knob to adjust the level. If you will be using the Balance
control as a SuperPair Volume control, then set these trims to 0.