Page 137
Removing an I/O Module
To remove a new 3G card, position the monitor with the rear panel facing you and
follow the instructions below.
1.
Place the monitor on a solid, static-free surface and remove the power
cord(s).
2.
Using a suitable socket wrench, adjustable wrench, or needle-nose pliers,
loosen the nuts on the gold BNC connectors and remove them.
3.
Using a small Phillips screwdriver, remove the top cover.
4.
Unseat the card from the slot and remove the card (still connected to the
rear panel) through the rear panel opening.
5.
Cover the rear panel opening with a blank rear panel cover.
6.
Insert the rear panel cover screws and tighten.
7.
Replace the lid and the screws.
Note:
All presets will be set to a factory default appropriate for the new
arrangement of cards.
CAUTION!
Static discharge can cause serious damage to sensitive
semiconductor devices. Avoid handling the circuit boards in high
static environments such as carpeted areas, and when synthetic or
wool fiber clothing is worn.
Touch the frame to dissipate static charge before removing boards
from a frame, and always exercise proper grounding precautions
when handling circuit boards.
WARNING!
Do not attempt to operate the monitor without all rear panel
cover plates in place. Doing so will compromise the unit’s
shielding.
Содержание AMP2-16V-M
Страница 170: ...Page 163 Figure B 8 Deleting Stream Destinations...
