Wohler AMP2-16V-M, Руководство пользователя

Страница: 25 / 172

Page 18
Canada.
Rear Panel Connectors
Standard Connectors
The AMP2-16V Series monitor back panel contains all of the connectors except for
the headphone jack as shown in Figure 2–1. Note that, as you are facing the rear
panel, the audio module slots are numbered from right to left.
1. Power: The AMP2-16V Series monitors use a standard IEC power cord for
the 100 to 240 VAC power connection. A redundant power supply is optional.
(Refer to Table 6-7 for a complete list of Option Kits).
2. Ethernet: The Ethernet port is used for system software upgrades.
3. Serial (Console): This DB-9F connector is used for factory diagnostic
purposes.
4.
Genlock Ref Input and Pass-Through (Ref): These BNC connectors are
designed to be used in a daisy-chained series arrangement from unit to unit.
A 75Ω BNC terminator (not supplied) must be installed in the open Ref
connector of the last unit in the chain. These inputs accept composite video
sync sources.
Figure 2–1: Typical Back Panel Layout
Unused AES Outputs
3G/HD/SD-
SDI Inputs
Genlock Ref Input
and Pass Through
Blank Cover Plate for
Optional Redundant
Power Supply
Blank Cover Plates for
Additional I/O Modules
IEC Power
Connector
Slot 1 Slot 2 Slot 3 Slot 4 Slot 5 Serial Port
Ethernet Port
Re-embedded
SDI Output
Optional I/O Modules and Rear Panel Connectors
The AMP2-16V Series monitors can include any combination of the optional I/O
modules listed in Table 2–1.