WhitakerAudio 60 W Stereo Power Amplifier, Руководство пользователя и по сборке

Страница: 79 / 154

79
60 W Stereo Power Amplifier
– Prepare a 5-inch long audio cable. Attach connector pins to each of the two wires on one
end of the audio cable. Insert the connector pins into the socket housing as follows: shield
to position #1 and white to position #2.
– Cut two short pieces of small heat-shrink tubing, each about 3/4-inch long. Place the
tubing at each end of the audio cable. Process.
– Insert the Molex socket into the Conn2 connector on the right channel PWB. Note that the
drain wire goes to the first “GND” position.
– Attach the shield wire of the audio cable to terminal #1 (low) on the right channel volume
control, R19. Do not solder.
– Attach the white wire of the audio cable to terminal #2 (arm) on the right channel volume
control. Solder. Dress the cable against the chassis.
– Prepare a 5-inch long audio cable. Attach connector pins to each of the two wires on one
end of the audio cable. Insert the connector pins into the socket housing as follows: shield
to position #1 and white to position #2.
– Cut two short pieces of small heat-shrink tubing, each about 3/4-inch long. Place the
tubing at each end of the audio cable. Process.
– Insert the Molex socket into the Conn2 connector on the left channel PWB. Note that the
drain wire goes to the first “GND” position.
– Attach the shield wire of the audio cable to terminal #1 (low) on the left channel volume
control, R19. Do not solder.
– Attach the white wire of the audio cable to terminal #2 (arm) on the left channel volume
control. Solder.
– Prepare a 26-inch long audio cable. Attach connector pins to each of the two wires on one
end of the audio cable. Insert the connector pins into the socket housing as follows: shield
to position #1 and white to position #2.
– Cut two short pieces of small heat-shrink tubing, each about 3/4-inch long. Place the
tubing at each end of the audio cable. Process.