WhitakerAudio 60 W Stereo Power Amplifier, Руководство пользователя и по сборке, Страница: 80 / 154

80
WhitakerAudio
– Insert the Molex socket into the Conn1 connector on the right channel PWB. Note that the
drain wire goes to the first “GND” position.
– Route the cable to the rear of the chassis using the cable clamps along the side of the
chassis.
– Attach a connector pin to the white wire in the audio cable from Conn1 on the right
channel PWB. Clip off the shield as it is not used. Insert the connector pin into the socket
housing as follows: white to position #2.
– Prepare a 26-inch long audio cable. Attach connector pins to each of the two wires on one
end of the audio cable. Insert the connector pins into the socket housing as follows: shield
to position #1 and white to position #2.
– Cut two short pieces of small heat-shrink tubing, each about 3/4-inch long. Place the
tubing at each end of the audio cable. Process.
– Insert the Molex socket into the Conn1 connector on the left channel PWB. Note that the
drain wire goes to the first “GND” position.
– Route the cable to the rear of the chassis using the cable clamps along the side of the
chassis. Position the wire away from the left channel volume control.
– Attach a connector pin to the white wire in the audio cable from Conn1 on the left channel
PWB. Clip off the shield wire as it is not used. Insert the connector pin into the socket
housing as follows: white to position #2.
– Prepare a 26-inch long audio cable. Cut two short pieces of small heat-shrink tubing, each
about 3/4-inch long. Place the tubing at each end of the audio cable. Process.
– Connect the white wire of the cable just prepared to the high side (terminal 3) of the right
channel volume control. Solder in place. Connect the shield wire to the low side of the
right channel volume control (terminal 1). Solder in place (2 wires).
– Route the audio cable to the rear panel using the cable clamps provided along the side of
the chassis.