Wexxar WF-10T, Руководство по эксплуатации и обслуживанию

Страница: 77 / 156

WF-10T Case Former Case Size Adjustments
7-65
7.11 Conveyor Case Width Dimension ‘D3’ Adjustment
Before making any machine adjustments, refer
to the shutdown procedure outlined in Section
6.5:
‘Shutdown’
.
The most practical way to adjust the conveyor
width to the case size is to use a formed case.
The conveyor width can be adjusted by using
the hand crank to move the side-belt
conveyors
IN
or
OUT
to fit the width of the
case. Adjust the drivebelts in until it is just
possible to remove it, then turn the adjustment
crank in a further ½ turn, or until the case just
slides easily between the infeed guides. There
is no locking mechanism for this adjustment.
The spring-loaded pressure plates behind the
conveyor side-belts in the tape sealing area
are more absorptive than any of our other WF
Series machines due to the long length of the
conveyor belts and the precision control
required to prevent the ‘squashing’ of the case
sides that make contact with the belts.
Check the ‘S’ box for Satisfactory Performance and ‘US’ box for Unsatisfactory Performance.
Table 19: Dimension ‘D3’ Adjustments
Size Adjustments
Conveyor Formed Case Width Adjustment (Dimension ‘D3’)
S US
Measure the outside dimension of the formed case width on the scale
provided.
Use the side hand crank to move the side-belt conveyors
IN
or
OUT
to fit the
width of the case.
Use a formed case to verify the measurement.
Figure 7-27: Dimension
‘D3’ Case Width Adjust
Figure 7-28: Case Width
Verification