Wexxar WF-10T, Руководство по эксплуатации и обслуживанию

Страница: 21 / 156

WF-10T Case Former Installation
2-9
2.6.2 Electrical Power
Before attempting any electrical connections, check the machine’s set-up voltage. This is listed
on a label on the inside of the access panel of the electrical enclosure. The standard WEXXAR
WF-10T voltage is 120V 60Hz 1-Phase, but alternate voltages are accommodated to meet
specific customer requests.
Electrical power is required to be connected to the designated high voltage terminals on the side
of the main electrical disconnect. The machine must also be properly grounded. All wiring must
comply with applicable local codes. For a copy of the machine’s wiring diagram, refer to the
drawings attached to this manual.
When electrical power has been connected and all access doors are closed, switch the main
disconnect switch
ON
. Check that all
‘EMERGENCY STOP’
buttons are in the
OFF
position.
Press the
‘RESET’
button on the control panel. Press the
‘START’
button on the touchscreen.
Refer to Section 5:
‘Controls’
for further information on machine controls.
The drive motor should be
ON
. Verify the direction of the drive motor.
Allow the machine to run for ten minutes to ensure that the factory preset motor overloads do not
trip. Minor adjustments to these components may be necessary to compensate for voltage
variations.
A dedicated electrical circuit is recommended for this machine. Any electrical connections
required before installing the machine must be conducted by an electrician qualified in your
jurisdiction.
2.6.3 Installing the Tape Heads
Tape dispensing heads are mounted with pins on their sides that fit into corresponding slots in the
tape head mounting brackets. Machines are usually shipped with the tape head secured in its
brackets. If it needs to be lowered into the brackets, align the pins on the side of the tape heads
with the slots in the brackets as follows:
On the tape head, slide the front pins on the head down and back into the key-shaped slots. The
rear pins will then drop into the vertical slots on the bracket. The head is held in place by its own
weight.
Please consult the tape head manual for instructions on the mounting of tape rolls and the proper
threading of tape through the applicator head.