Wexxar WF-10T, Руководство по эксплуатации и обслуживанию

Страница: 19 / 156

WF-10T Case Former Installation
2-7
2.5
Location, Leveling and Conveyors
2.5.1 Location
When selecting the machine location, carefully consider the following points:
•
Adequate access around the machine for correct operation and service.
•
Sufficient room to open the guards and access doors (including control enclosure).
•
A minimum 3-foot clearance in front of the main electrical enclosure.
•
Easy lift-truck access.
•
Good access for magazine loading and nearby space for pallet loads of flat cases
.
2.5.2 Leveling
•
Use at least a two-foot carpenter level, marked on one end so that you always work to
the same bubble line and with the concave side down (if there is one).
•
Open the guard doors, and position the spirit level along the length of the main frame to
level one side of the machine.
•
Adjust the machine leveling feet on this side of the machine as appropriate to centralize
the bubble between the parallel lines.
•
Position the spirit level on the main frame along the width of the machine at the discharge
end.
•
Adjust the machine leveling feet under the magazine and discharge ends on the opposite
side in order to centralize the bubble between the parallels.
•
Tighten the level adjuster lock nuts.
•
Anchor the machine to the floor.
The machine should be kept level in order to avoid frame stress and ensure optimum
performance. An adjustable height footpad kit is included as standard equipment, and can be
used to level the machine on an uneven floor.
The machine should be anchored to adjoining equipment or to the floor in order to prevent any
movement of the machine by reactive forces that may occur as sealed cases are being driven
through the machine outfeed.
2.5.3 Discharge Conveyor
The discharge conveyor is customer supplied and may be a gravity-fed or powered type. If the
discharge conveyor is powered, a smooth top surface is preferred. It is important to note that the
case discharge mechanism is designed to discharge the case against zero restraint. It is not
intended to overcome the friction of a long conveyor filled with cases, or push cases up an
inclined slope. Excessive discharge friction will cause improper machine operation.
CAUTION!
The machine should NOT be operated on casters.