Wexxar WF-10T, Руководство по эксплуатации и обслуживанию

Страница: 40 / 156

WF-10T Case Former Controls
5-28
5.4
JOG Mode
This feature is useful for training purposes or for troubleshooting. See Section 9.3:
‘Machine
Sequence Troubleshooting’
. Touch the
‘JOG CONTROL’
button on the
‘Main Control’
screen to
enter into
JOG
mode. Touching the
‘JOG CONTROL’
button displays the
‘Jog Control’
screen.
Touch the
‘START’
button in
JOG
mode to cycle the machine through its operational sequence,
one step for each push of the button.
14) ‘Jog Control’ Screen
Along the bottom of the screen, sensor status indicators show which
sensors are activated during each step. As the machine is jogged
through its steps, each sensor indicator, in turn, flashes repeatedly
until that machine step is complete, at which time the sensor is
continuously illuminated until the machine is jogged to the next step.
For troubleshooting instructions, please refer to Section 10:
‘Troubleshooting & Repairs’
.
15) ‘MACHINE CYCLE JOG’ Button
In the center of the
‘Jog Control’
screen is the
‘MACHINE CYCLE
JOG’
button. Each time it is pressed, the machine moves through a
single step of the box-forming process. At the top of the screen, the
display shows what the next step will be when the
‘MACHINE CYCLE
JOG’
pushbutton is pushed again.
16) ‘SETUP’ Button
To change any of the machine control settings for purposes such as
activating or deactivating the
BOX CALL
operation, the
‘REMOTE
DEMAND’
sensor or
DRY CYCLE
operation for the purpose of
troubleshooting, press the
‘SETUP’
button in the bottom right-hand
corner of either the
‘Jog Control’
or
‘Main Control’
screens. The
‘SETUP’
button disappears from the
‘Main Control’
screen when the
machine is running in
CYCLE
mode.
Figure 5-18: ‘Jog Control’
Screen
Figure 5-19: JOG CONTROL
Status Indicator Illuminated
Figure 5-20: Sensor
Status Indicator
Figure 5-21: 'MACHINE
CYCLE JOG' Button
Figure 5-22: 'SETUP'
Button