Wexxar WF-10T, Руководство по эксплуатации и обслуживанию

Страница: 38 / 156

WF-10T Case Former Controls
5-26
8) ‘TOTAL NUMBER OF CASES’ Button and Display
The
‘TOTAL NUMBER OF CASES’
display indicates the total number of cases formed. This
counter can be reset to 0. The reset button is the blue word ‘
RESET’
. When this button is
touched, a confirmation message will appear. To reset the case counter to 0, touch ‘Yes’. Below
the
‘TOTAL NUMBER OF CASES’
display is the
ACTUAL CPM
(cases per minute) display.
9) ‘LARGE BOX/SMALL BOX’ Button
Beneath the
‘ACTUAL CPM’
display is the
‘LARGE BOX/SMALL
BOX’
button which indicates which of these two settings the
machine is running in. Touch the
‘LARGE BOX/SMALL BOX’
button to bring up the
‘Box Setup’
screen.
5.3
AUTOMATIC CYCLE Mode
On the
‘Main Control’
screen, ensure that the machine is in the correct mode. If the machine is
in
JOG
mode, press the
‘MAIN CONTROL’
button to put the machine into
AUTOMATIC CYCLE
mode. Then press the
‘START’
button to run the machine in
AUTOMATIC CYCLE
mode. Press
the
‘STOP’
button to stop the machine after the current cycle is completed. The green
AUTOMATIC CYCLE
light on the beacon tower will illuminate and stay illuminated until the
machine is stopped by a machine fault input, or by one of the following conditions:
‘STOP’
,
‘EMERGENCY STOP’
, or
‘GUARD DOOR OPEN’
.
Figure 5-11: 'Box Setup' Screen
10) ‘Box Setup’ Screen
In the
‘Box Setup’
screen, machine adjustments can be made to make
longer boxes or shorter ones (Dimension C). If the Dimension C of the
box to be made measures between 14 and 20 inches, touch the
‘LARGE
BOX’
button in the upper left-hand side of the screen. If the Dimension
C of the box to be made measures between 9 and 13 inches, choose the
‘SMALL BOX’
button in the upper right-hand side of the screen.
Whichever button is touched turns green, and the machine’s settings are
adjusted to fit the chosen box size.
Figure 5-10: 'LARGE BOX
/ SMALL BOX’ Button
Figure 5-12: Box Size
Selection Button