Wexxar WF-10T, Руководство по эксплуатации и обслуживанию

Страница: 66 / 156

WF-10T Case Former Case Size Adjustments
7-54
7.6
Case Blank Length Dimension ‘A’ Adjustment
Before making any machine adjustments,
refer to the shutdown procedure outlined in
Section 6.5:
‘Shutdown’
.
Using the detachable Dimension ‘A’ hand
crank located on the operator’s side of the
machine, adjust the pointer to the measured
case blank length, Dimension ‘A’.
Test the measurement by loading case blank
stacks into the magazine as described in
Section 6.3.2:
‘Loading the Magazine’
. The
case blanks loaded in the magazine should
slide along the hopper guide rails without
resistance in order to prevent any build-up of
friction.
Check the ‘S’ box for Satisfactory Performance and ‘US’ box for Unsatisfactory Performance.
Table 12: Dimension ‘A’ Adjustments
Size Adjustments
Case Blank Length Adjustment (Dimension ‘A’)
S US
Measure the outside dimension of the case blank length on the scale
provided.
Adjust the detachable Dimension ‘A’ hand crank until it approaches
the width of the case blank.
Load a stack of case blanks into the walk-in magazine, making sure to
orient them correctly. They should now be resting on the infeed
support bars.
Position the magazine pushers upstream of the case blanks as
described in Section 6.3.3:
‘Magazine Pushers’
.
Finish adjusting the hand crank until there is s sliding fit between the
sides of the case blank stack and the hopper guide rails.
Figure 7-4: Dimension
‘A’ Hand Crank
Figure 7-5: Dimension
‘A’ Pointer
Figure 7-6: Magazine
Width
A