Welch Allyn RetinaVue 100 Imager, Инструкция по применению

Страница: 102 / 116

Note
Use a safe eject method when ejecting the SD card to
ensure a complete software transfer to the SD card.
(Options include right-clicking on the
Start Menu > Open
Windows Explorer> right-click on SD card> click Eject . Or,
click on the Taskbar> Show hidden icons > click Safely
Remove Hardware and Eject Media> click Eject SDHC ).
If an eject menu is not available with your system settings,
wait until the files have completely copied before manually
ejecting the SD Card.
9. Remove the SD Card from the computer.
10. Insert the SD Card into the RetinaVue 100 Imager.
11. Place the RetinaVue 100 Imager on the docking station charger, connect the docking
station charger via a USB cable to the power source, and then power up the
RetinaVue 100 Imager.
Note The update process typically takes a few minutes to cycle
through the complete update. During the update process, it
is normal to see both a blank screen and an update screen
that appear several times before the RetinaVue 100 Imager
automatically reboots.
12. After the RetinaVue 100 Imager boots up to the Home screen, confirm the software
update.
a. Touch
Settings .
b. Touch About to view the software version.
13. Touch OK .
Update the RetinaVue 100 Imager connection settings (USB and wireless)
Complete the following steps to update or change USB or wireless connection
settings:
14. Touch Advanced settings .
15. Touch Restore factory defaults .
16. Touch OK at the prompt: Reset all the settings to defaults .
17. Touch OK at the prompt: All settings were restored to factory defaults .
You are ready to use the updated software. See either topic First time selection of
USB connectivity workflow or First time selection of Wi-Fi connectivity workflow for
further information about first time set up of USB or wireless connectivity.
Troubleshooting software updates
Note The RetinaVue 100 Imager boots up normally after a successful software
update, however if a software update fails, the RetinaVue 100 Imager
displays a failed update error message.
Power loss during software update:
• If a power loss occurs during the software update or if there are hardware issues,
the RetinaVue 100 Imager posts a blank screen. Remove the battery, reinstall it, and
restart RetinaVue 100 Imager. By performing this power cycle, the RetinaVue 100
Imager reverts to a previous version of software. Repeat the steps to perform the
update again.
Corrupted software files:
98 Appendix Welch Allyn RetinaVue™ 100 Imager