Voltech AT5600, Руководство пользователя

Страница: 201 / 438

C H A P T E R 9 – T R O U B L E S H O O T I N G
AT5600 User Manual 98-119 issue 14
Page 201
Status Error Codes
Hex Code Meaning
0000 Test passed with no errors.
xxx1 Voltage over-range occurred.
xxx2 Current over-range occurred.
xxx4 Ramp-up process has been aborted; too much load.
xxx8
Error reported by the DC bias unit or that the DC bias unit did not respond to a
command.
xx2x
The test signal could not be trimmed to required value; incorrect test parameters
for the load.
xx4x An error occurred after ramp-down; current did not decay away in time.
x1xx Current limit fail (Hi-pot tests only); test current exceeded pre-programmed limit.
x2xx
The measured voltage did not go away in time; something on the fixture is staying
charged.
#4xx The test has been interrupted (see table below).
Where # = reason for the interrupt.
1 The safety interlock was broken during the test
2
Power more than limit requested. Power is above 25W. If this power level is
exceeded, we abort the test
3
A Hi-pot current trip has terminated the test; i.e. a flashover (spark) has occurred
or the current has exceeded the AT’s current capabilities (can occur on HPAC,
HPDC, ACRT, DCRT and IR).
4
A STOP input has terminated the test from the STOP input of the remote port or
the STOP button on the front panel
5 An 8KV overvoltage has been detected and terminated the test.
6
Class D overload. A hardware trip to protect the unit if >4A has been detected for
greater than a few microseconds.
7 An over-temperature interrupt has terminated the test; unit has become too hot.
8
An auxiliary fault interrupt has terminated the test; this can be created by an
accessory attached to the peripheral port.
9 Unit rebooted during the test sequence.