FCC ID: K6620285X20
IC ID: 511B-20285X20
VX-3R Operating Manual
5. Press the [TXPO] key momentarily to enable programming of the personal ID.
6. Press the [HM/RV] key to clear the previously stored personal ID, if desired.
7. Rotate the DIAL knob to select the first character of the personal ID you wish to store, and then press
the [V/M] key to save the first character of the personal ID and move on to the next place.
8. Repeat previous step to complete the personal ID (up to 8 characters). If you make a mistake, press
the [BAND] key to move back to the incorrect character, then re-enter the correct character.
9. Press the [HM/RV] key to delete all data after the cursor that may have been previously stored
erroneously.
10. When the personal ID entry is complete, press the [TXPO] key momentarily.
11. If you wish to store another personal ID, repeat steps 3 through 10 above.
12. Press the PTT switch to exit to normal operation.
Set your Personal ID
You choose your personal ID from the member list.
1. Press and hold in the [TXPO] key for one second to enter the Set mode.
2. Rotate the DIAL knob to select Set Mode Item 56: MSG.REG.
Note: Do not forget to pull the DIAL knob to rotate the DIAL knob.
3. Press the [TXPO] key momentarily to enable adjustment of this Set Mode Item.
4. Rotate the DIAL knob to select the member box (1 ~ 20) where your ID is stored.
5. Press the PTT switch to save the new setting and exit to normal operation.
Sending a Messages
The registered message can be sent to the members who are receiving the coordination frequency.
When a message is sent, the transmitter’s ID will be sent also, and the receiver can identify who sent the
message.
Note: The “Personal ID” setting (described previous paragraph) is required for the transmitter’s ID to be
shown with the received message.
1. Set the radio to the coordination frequency.
2. Press and hold in the [TXPO] key for one second to enter the Set mode.
3. Rotate the DIAL knob to select Set Mode Item 79: SQ TYP.
Note: Do not forget to pull the DIAL knob to rotate the DIAL knob.
4. Press the [TXPO] key momentarily to enable adjustment of this Set Mode Item.
5. Rotate the DIAL knob to select “MESSAGE” (to activate the Message feature).
6. Press the [TXPO] key momentarily, then rotate the DIAL knob to select Set Mode Item 57: MEG.SEL.
7. Press the [TXPO] key momentarily to enable adjustment of this Set Mode Item.
8. Rotate the DIAL to select the message you wish to send.
Vertex Standard Co., Ltd.
47