19
13. WIRELESS REMOTE SETTINGS & OPERATION
The wireless receiver and remote transmitter are pre-set at
the factory to the codes and configurations shown below. A
9-volt battery will also be installed in the transmitter at the
factory. If your transmitter fails to operate the lift, first make
sure the lift power cord is plugged in and the power switch
on the rear of the motor housing is turned ON and lighted.
The indicator will light at the top of the transmitter when
either the up or down button is pushed and a signal is being
transmitted. If the indicator does not light and the
transmitter fails to operate the lift, replace the battery with a
fresh 9-volt battery. When opening the battery compartment,
the dip switches can be accidentally moved out of place.
See the Owners Manual, page 13 for complete details
about operation and settings of the remote transmitter.
14. CHANGING CODES & CONFIGURATION SETTINGS
Normally you will not need to change the factory settings
unless someone within a block of you is operating a Versa
Lift wireless model too or you are getting interference from
some other radio frequency device, tower, or broadcasting
station nearby.
If you are having interference problems,
see the Owners Manual, page 13 for complete details
about operation and settings of the remote transmitter.
Congratulations! Your installation is now complete!
Please read and understand the
Owners Manual
completely to learn important safety rules you
need to know before operating this lift system!
Read and understand the
Owners Manual completely before operating
this lift! The Owners Manual provides many
IMPORTANT SAFETY FACTS THAT YOU MUST
KNOW BEFORE USING THIS PRODUCT!
WARNING
!
Versa Lift
Remote/Receiver Settings
(Wireless Models)
12. INSTALLING THE STABILIZER BRACKETS:
Note:
The stabilizer brackets have larger holes on one
end and smaller holes on the other end. Position the
stabilizer bracket with the small-hole end at the top and
the large-hole end on the floor. The bracket should form
a 45 degree brace with the ends in flush contact with
both the floor and the housing leg (Fig. 36).
Step 1:
Position the stabilizer bracket as detailed above
under the motor-end of the lifting head (Fig. 36). Install
the #12 x 1” screws through the larger holes and into the
floor decking. Tighten screws snug, but don’t strip them
out.
Step 2:
Using a power driver or drill, install the drill-point
screws through the smaller holes in the upper end of the
bracket and into the housing leg (Fig. 36). Take care not
to drive these screws too fast because when they
become tight the screw stops instantly. If you are driving
it too fast the screw can break or strip out!
IMPORTANT: For safety reasons, the stabilizer
brackets should be installed under the motor-end
(over-hang) of the lifting head so the brackets do not
project into your walking pathway! (See Fig. 36.)
LARGE HOLES
STABILIZER
BRACKETS (2)
STEP 1:
POSITION STABILIZER AS
SHOWN. INSTALL #12 x 1"
SCREWS (4) THRU LARGE
HOLES AND INTO FLOOR
STEP 2:
INSTALL DRILL-POINT
SCREWS (4) THRU SMALL
HOLES IN BRACKET AND
INTO HOUSING LEGS
HOUSING LEGS (
NOT
PLATFORM LEGS!)
SMALL HOLES
MOTOR-END
OF HOUSING
Fig. 36
(405) 516 2412
