13
CAUTION
!
DO NOT OPERATE THE
LIFT MOTOR UNTIL INSTRUCTED TO
DO SO IN STEP 9 OF THIS GUIDE!
Doing so will cause lift to malfunction!
Fig. 22b
2b. LIFT HEAD ASSEMBLY - ALL MODELS
This step requires two persons.
should be done in the attic. Locate the parts shown
below and move them up to the attic. The lift housing is
heavy and requires 2 able persons to move it up to the
attic. Place the lift housing on a rug or piece of cardboard
open-side-up as show below.
This assembly step
Assemble the four lift housing legs to the lift housing (Fig.
22b Inset).
The locknuts provided will not work loose,
so tighten the bolts and nuts firmly, but do not over-
tighten or you will collapse the square tubing.
Assemble the mounting rails to the lift housing legs (Fig.
22b) with bolts, washers and locknuts but do not tighten
them yet. Leave them slightly loose for Step 4.
Note: The legs fit on the INSIDE of the lift housing.
LIFT HOUSING
1/4-20
LOCKNUT (8)
LIFT HOUSING LEGS (4)
1/4x5/8" WASHER (16)
MOUNTING
RAILS (2)
1/4-20 x 1-1/2"
HEX BOLT (8)
1/4-20 x 1-1/2"
HEX BOLT (8)
1/4x5/8" WASHER (16)
1/4-20
LOCKNUT
(8)
LIFT HOUSING LEGS (4)
LIFT
HOUSING
Versa Lift
ASSEMBLY GUIDE
(All Models)
