REQUIRES 2 PERSONS:
SLIDE THE LIFT HOUSING
ASSEMBLY INTO POSITION
INSTALL LAG SCREWS,
BUT DO NOT TIGHTEN
(8) PRE-DRILLED
5/32" PILOT HOLES
(SEE FIG. 4, PG. 4)
INSTALL 1/4 x 3"
LAG SCREWS (8)
1/4" x 1" DIA. WASHER (8)
PLACE LEVEL ON HOUSING. USE SHIMS
UNDER LEGS TO LEVEL HOUSING, THEN
TIGHTEN LEG BOLTS (SEE INSET).
HOUSING LEG
2. TIGHTEN
LEG BOLTS
1. ADD SHIMS
UNDER LEG
Fig. 23
Fig. 24
14
Versa Lift
ASSEMBLY GUIDE
(All Models)
3. INSTALLING THE LIFT HEAD
This step requires two persons.
Turn the lift head
assembly upright and position it in front of the opening
(Fig. 23). With one person on each end, lift slightly and
move the assembly over the opening (Fig. 23) and align
the slots in the mounting rails with the pilot holes in the
decking. Install the 8 lag screws and 1” diameter washers
into the pilot holes and screw them down untill they
almost contact the mounting rail, but leave them loose so
the mounting rails can be adjusted later (Fig. 23 inset).
4. LEVEL THE LIFT HEAD
The bolts that hold the legs to the mounting rail must be
loose for this step. Place a bubble level lengthwise on the
housing and see if head is level (Fig. 24). Place shims
under both legs on the low end (Fig. 24 inset). Adjust the
shims until the head is level and then tighten all 8 leg
bolts (Fig. 24 inset).
