Velocity Operation Manual
www.velocitydetection.com
65
Next, configure the network mode.
Disabled:
The network connection is disabled
Enabled local:
The local panel will not receive alarm and fault
messages from remote panels.
Enabled global:
The local panel will receive alarm and fault messages
from remote panels.
Press tick
to save the changes.
Repeat the above steps for every Velocity panel on the
network.
Then press the Add icon
to search and configure
the network.
When the search is complete, the panel shows a list of
network node addresses seen, and whether the panel
sees a connection on Network port A (NET 1), and
Network port B (NET 2).
If the panel sees a connection it reports the port as UP. If
it does not see a connection, it reports the port as down.
(In this example we have a four panel network)
The icon
can be pressed to rescan the network.
Running the Network
On a Velocity panel, running in a network, all events are reported at all panels. All panels are able to silence & reset the system, when a
suitable access code has been entered.
Operation of outputs over the network is determined by the programmed cause & effect. Any input on the network can be
programmed to operate any output. The cause & effect is entered at the panel that has the INPUT CAUSE connected.
