UBI EasyCoder 501, Техническое руководство

Страница: 39 / 106

39
UBI EasyCoder 501 – Technical Manual
❑ You can check the present value of the LSS by pressing the
< F1 > key on an EasyCoder 501 E or the < Ins > key on an
EasyCoder 501 SA. The value will be displayed in the centre of
the menu, e.g.:
LABEL <103> GAP
■
❑ Press < F1 > or < Ins > again and the value disappears. This
facility can be used any time during the LSS setup operation.
❑ Label (w gaps):
Put a piece of paper with backing paper between the two parts
of the sensor. The cursor should appear at the left side of the
menu:
LABEL <103> GAP
■
Put a piece of backing paper without any label into the sensor.
The cursor should move to the centre of the menu:
LABEL <103> GAP
■
Finally remove all paper web from the sensor. The cursor should
move to the right side of the menu:
LABEL <103> GAP
■
❑ Ticket (w mark):
Put the paper between the two parts of the sensor, making sure
there is no black mark close to the LSS. The cursor should appear
at the right side of the menu:
MARK <103>TICKET
■
Move the paper so the black mark becomes situated above the
sensor. The cursor should move to the left side of the menu (the
same applies when no paper is fitted):
MARK <103>TICKET
■
Detection, cont'd.
Continued!
SETTING UP EASYCODER 501 E & 501 SA, cont'd.